Peter Harkins

image

Step 2 ^

image

Step 1 ^

image
image
image

I really enjoyed this assignment even though there were times that it became difficult and frustrating.

For step one, I create an arc and then extruded upward and created both the U and the V layout for adaptive seamless panels to be attached. Then applied the image to them but the difficulty came in laying out the image correctly. Not only will the upside down but it was also mirror imaged. To de-jumble the image, I swapped the U and the V parameters and then was able to make the image right side up through a series of transpositions.

For step two I created a wall, but had difficulty with the ‘s” shape. I failed to turn on the amplitude high enough to show any of the s shape. I finally figured it out after a long period of messing around with the model.

image
image

I applied a new image to the wall and explored with my parameters to extend different parts of the wall out. First based on color(first image below), then on brightness. When I change the brightness parameter it looked more appealing(second image below).

image
image